AIRE Vaporizer H2.1 Instructions

Direct Inhalation Instructions

1. Place the blend of choice into the crucible of the AIRE Vaporizer H2.1.
   
   Start experimenting with small quantities i.e. a "pea" sized sample. Do not grind the blend before putting them into the AIRE Vaporizer H2.1.
   
   The AIRE Vaporizer H2.1 will vaporize all active ingredients within the blend, even those without an exposed surface.
   
   
2. Insert the main mouthpiece of the AIRE Vaporizer H2.1. This mouthpiece was designed to fit in easily when the unit is cool.
   
   As the AIRE Vaporizer H2.1 heats this mouthpiece expands slightly, creating a tight seal.
   
   
3. Insert the mouthpiece extensions into the main mouthpiece by rotating during insertion until resistance is felt.
   
   
4. Plug in the AIRE Vaporizer H2.1 and turn the temperature knob to the desired temperature.
   (Red LED "on" indicator lights glow from under the AIRE Vaporizer H2.1)
   
   
5. The tri-colored LED will change to amber when the desired temperature is achieved.
   
   The light will turn green when the actual temperature is below the selected temperature. (Too cool)
   
   The light will turn red when the actual temperature is above the selected temperature. (Too hot)
   
   
6. When the light is amber slowly inhale through the mouthpiece extension.
   
   The air will be much smoother than smoking (no combustion) making it important only to inhale half as much as you would when burning the blend.
   
   Be careful that the back air intake tube remains uncovered. It is normal operation when the light cycles between the colors as the AIRE Vaporizer H2.1 maintains the selected temperature.

For most blends, start in the low 165°c / 330°F range. AIRE Vaporizer H2.1 technology provides vaporization at these remarkably low temperatures. Higher temperatures will produce a denser vapor, but may be harsher.

The AIRE Vaporizer H2.1 has an automatic shutdown feature. The unit hot air generator will shutdown and blink green 30 minutes from the last time the dial is adjusted. Simply turn the dial off and back on to reset.

AIRE Vaporizer H2.1 Bag Fill Set-Up

1. Insert one end of the tubing into the air outlet on the air pump and the other end with the connector into the air intake hole on the back of the AIRE Vaporizer H2.1.
   
   
2. Connect the ready bag mouthpiece onto the end of the mouthpiece extension while pressing and using a twisting motion.
   
   
3. Turn on the air pump with the switch on the cord.
   
   
4. Watch the bag fill with potent vapors. Remove the bag when it is full. Caution: Avoid over-filling the bag.
   
   As you enjoy the first bag, place the second ready bag onto the AIRE Vaporizer H2.1.