Easy Vape Vaporizer Instructions
ON PURCHASE ONLY:
Insert fuse (2amp) into back of
vaporizer unit, needed to function.
Turn on vaporizer unit and
increase the temperature to its
highest setting.
Let the unit run at this level for 15
minutes. As this will burn off the
manufactures packing oils on the
ceramic heating element.
Make sure you do this
in a well ventilated area.
Getting Ready to Use the Easy Vape Vaporizer
Turn on the vaporizer unit by
pushing in the knob on the front of
the unit and increase the
temperature to 320 - 350 degrees
by turning the knob clockwise and
adjusting the temperature.
(Check the heating element for a
dim red glow. If the heating
element is bright orange turn
off for 10 seconds and reset)
Now let the vaporizer unit warm
up for two minutes. When unit is
ready, place the vapor whip filled
with your smoking material over the heating element.
Grind up material and suck up into
the tip of the glass hand piece.
Recommended load is 1/3 or less of the bowl volume (from screen
to tip) lightly packed down.
Vaporizing with the Easy Vape Vaporizer
Exhale all your breath and place
your mouth to the mouthpiece of
the vapor whip.
Touch the Pyrex tip to the glass
slipper covering the heating
element, hold it there and take a
continuous steady breaths releasing the Pyrex tip from the
element right before you are done
in order to clear the tube.
If you draw too slowly and the
heating element is too hot, you
may catch the material on fire. In
this case blowout immediately and repack with fresh material.
Be sure to experiment with
different settings and varying
draw velocities.
Smoking Technique
The material can be packed down
using the blunt end of the poker, a
pen, or a pencil.
Over-packing
reduces airflow and results in
overcooked or burned materials.)
Expel material by blowing whip
into a bottle, can, or plastic
container. If some material
remains in the tip it may
not be thoroughly cooked.
Moist material does not seem to
work as efficiently, although it can
work just fine.
Easy Vape Digital Vaporizer Warranty
The Easy Vape Digital Vaporizer was made with replaceable fuses so that surges or electric fluctuations wouldn’t burn out the system only blow the fuse. This expands the life span of the unit significantly.
The Easy Vape Digital Vaporizer comes standard with a 5 year Warranty *.
You can at your option extend your warranty on the Easy Vape Digital Vaporizer to a lifetime warranty for an additional $49.99.
* Easy Vape Digital Vaporizer 5 year warranty applies to heater failure only.
Glassware and physical damage to the Easy Vape Digital Vaporizer are not covered under warranty.
|