Vapir Air One 5.0 Vaporizer Instructions

Vapir Air One 5.0 Vaporizer Balloon Inflation Kits Instructions

Cut the tube to a length of 3-4 inches for best results when using with the balloon.

This Vapir ONE is equipped with a new supercharged heater.

Changing the fan speed may or may not noticeably affect the temperature. It is not necessary to heat up your unit to the maximum temperature to inflate balloons.

Please use a moderate temperature between 170ºC/300ºF and 176ºC/350ºF when preheating your unit. Using a higher temperature may cause burning of your herbs.

H = HIGH M = MEDIUM L = LOW

Due to the high speed of the airflow the temperature will drop rapidly when the fan is switched to the H position.

Effective Balloon Inflation Tips

1. Set the fan in the L position and set your desired temperature.
2. When the actual temperature reaches the set temperature, attach the ballon and insert your 1/2 filled herb disk into the drawer.
3. Wait about 10 - 15 seconds then set the fan to the M or H position. The balloon will start to inflate. When using the M fan position to inflate a balloon you will get denser vapor but the balloon will fill up slower. When using the H fan position to inflate a balloon you will get a less dense vapor but the balloon will fill up more quickly.
4. When balloon stops expanding, detach the balloon and inhale. Also turn the fan back down to L to allow the Vaporizer to heat back up to desired temperature.
5. While inhaling remove the herb drawer so you do not waste any vapor. When you are finished inhaling the previously filled balloon, repeat steps 2 - 4.

Important Note

• The quantity of balloons you inflate with vapor from one filled disk will depend on many factors, including the condition of your herbs.
• Most vapors are invisible or slightly grey. You should always taste the flavor of your herbs and you may see some slight grey vapor.

Vapir Air One 5.0 Vaporizer Quick Links