Vapir Air One 5.0 Vaporizer Important Operating Instructions
Below find step by step instructions on using the
Vapir
Air One 5.0 Vaporizer.
Due To High Air Pressure, Temperatures May Fluctuate Several Degrees Causing The Green Light To Flicker Between Red And Green. This Is Normal.
It is imperative that you place your Vaporizerīs fan setting on the HIGH or H position
when starting it up.
Failure to do this may cause damage to your Vaporizer that is
not covered under warranty.
This vaporizer has 3 Fan speed settings:
- L for LOW
- M for MEDIUM
- H for HIGH
The unit should always be started on H for HIGH so that it can
properly achieve the speed it requires. The unit might not operate properly if it is not
started on the HIGH position.
If the unit is heated without the fan on, it could possibly
overheat and cause damage to the unit that is not covered by the warranty In the event
that this occurs, immediately turn it off and restart on HIGH.
If your fan ever turns off or you notice it is not on, immediately turn the unit to the
off position, adjust the fan speed to H (HIGH position), and turn the unit on with the
heat off (heat is the large button with a flame on it). Do this for 5 minutes. It should
cool your device for usage.
Never unplug or turn your unit off until it has had sufficient time to cool down. Always
leave the fan running without heat for a minimum of 5 minutes after each use.
As a safety precaution, your unit is equipped with an internal safety switch. This switch
will disable your unit should it ever overheat. If your unit malfunctions or stops heating,
leave the fan on H (High position) for 20 minutes to cool the unit down.
Then, turn your
unit off. At this time, it is safe to either restart the unit or unplug it and store.
Always unplug the unit from the electrical outlet before cleaning.
Always make sure
your unit is completely dry before turning it on.
Do not attempt any repairs to your
unit as doing so may cause fatal injury or void your warranty.
Vapir Air One 5.0 Vaporizer Quick Links
» Important Start-Up Instructions
»
Filling the Herb Chamber
» Removing the Herb Disc
» Herb Tube Attachment
» Operational Instructions
» Balloon Inflation Kit Instructions
|
