Vapir Oxygen Vaporizer Instructions
Below find step by step instructions on using the
Vapir
Oxygen Vaporizer.
1. Pre-grind ¼ gram of herbal material.
It is crucial that you do not use more than ¼
gram.
Less is more when it comes to the Oxygen™
mini vaporizer. 2-3 scoops with the included
spoon is a good measure.
2. Preheat unit to 374ºF.
3. Set desired temperature using the temperature
+/- buttons. 374ºF is a good default.
However, it takes practice to get the perfect
temperature for your specific herbs. This will
require some trial and error on your part.
4. Press the Heat button to activate
heat. The red LED will indicate the unit
is heating. The screen will display first the
set temperature and then the actual temperature.
The green LED will indicate the set temperature
has been reached. It is normal for
the light to toggle back and forth between
red and green.
5. Once unit is preheated, twist
cap counterclockwise to remove mouthpiece.
6. Insert herbs using the included long
spoon. Never touch near or inside the unit when
it is hot.
7. Attach mouthpiece by turning it
clockwise.
8. Immediately begin by enhaling 2-4
deep breaths into the mouth piece. This will
allow the hot air to move evenly through your material.
Then begin to enjoy the flavor of the vapor. This
step can be repeated each time you wish to
enjoy the flavor.
9. Once you are finished, use the included
spoon to remove any herbs and herbal residue. You
may also want to use a simple wire brush (sold separately)
to clean the chamber after each use.
Note
To stop the heating process, press the Heat button.
This unit has a safety default heating time of 20
minutes.
It will automatically shut off after 20 minutes
of continuous use. If unit overheats: For added
safety there is a protective thermal switch inside
the unit to prevent damage to the unit from overheating.
When it is over heated, the thermal switch will
cut off power to the heater. The unit will cease
to function until it has sufficiently cooled down.
The heating process can only be restarted after
the unit is cooled. This will usually take 15 -
20 minutes.
|
