Da Buddha Vaporizer Instructions

Da Buddha Vaporizer Instructions

Turn Da Buddha Vaporizer on. There are a few ways to start this out.

First one can turn glass marble adjustment knob to full blast for about 2 minutes. Then turn the glass marble dial back down to about the 1/3. Most tobacco and blends for aromatherapy and homeopathic healing only need Da Buddha Vaporizer turned up 2/3.

The other way to turn the unit on is to just turn it to your favorite position (you will find this position after use) and wait 3-5 minutes. Either way the unit is very simple to turn on.

While Da Buddha Vaporizer is heating up grind or chop up your blend. Put a little amount of the ground blend in the wand, being careful not to pack the blend in the wand to tight.

The wand should only be filled from 1/8" to 1/4" of blend. You can fill the wand up as much as you want as long as your blend is not touching the glass heater on Da Buddha Vaporizer.

When you are vaporizing remember less is more. To put the ground blend in the wand you can put it in with your fingers, or suck it up off of a table or dish.Again only filling the wand with 1/8"-1/4" of tobacco and not packing in the wand.

Place the wand in the ground glass heater. When inserted you can start to inhale. This will draw air into the heater and warm it up to vaporizing temperatures. The air passes the plant matter and warms it until vaporization occurs.

You can stir your plant material in between vapor draws to increase the efficiency of the vaporization. The vapor is a light white cloud. To empty the wand, turn it upside down and empty into the trash.

You can blow through the mouth piece to get the plant matter out easier. Not too hard to go from smoking to vaporizing! A much better alternative!