Vapir Mini Oxygen Vaporizer 4.0 Instructions

1. Pre-grind ¼ gram of aromatherapy material. It is crucial that you do not use more than ¼ gram.
   
   Less is more when it comes to the Vapir Mini Oxygen Vaporizer 4.0 . 2-3 scoops with the included spoon is a good measure.
   
   
2. Preheat unit to 374ºF.
   
   
3. Set desired temperature using the temperature +/- buttons. 374ºF is a good default.
   
   However, it takes practice to get the perfect temperature for your specific blend. This will require some trial and error on your part.
   
   
4. Press the Heat button to activate heat. The red LED will indicate the unit is heating. The screen will display first the set temperature and then the actual temperature.
   
   The green LED will indicate the set temperature has been reached. It is normal for the light to toggle back and forth between red and green.
   
   
5. Once unit is preheated, twist cap counterclockwise to remove mouthpiece.
   
   
6. Insert blend using the included long spoon. Never touch near or inside the unit when it is hot.
   
   
7. Attach mouthpiece by turning it clockwise.
   
   
8. Immediately begin by enhaling 2-4 deep breaths into the mouth piece. This will allow the hot air to move evenly through your material.

   Then begin to enjoy the flavor of the vapor. This step can be repeated each time you wish to enjoy the flavor.
   

9. Once you are finished, use the included spoon to remove any blend and aromatherapy residue. You may also want to use a simple wire brush (sold separately) to clean the chamber after each use.
   

Note
To stop the heating process, press the Heat button. This unit has a safety default heating time of 20 minutes.

It will automatically shut off after 20 minutes of continuous use. If unit overheats: For added safety there is a protective thermal switch inside the unit to prevent damage to the unit from overheating.

When it is over heated, the thermal switch will cut off power to the heater. The unit will cease to function until it has sufficiently cooled down.

The heating process can only be restarted after the unit is cooled. This will usually take 15 - 20 minutes.