Puffco Accessories

The pieces here are made for the Peak and Peak Pro, the Proxy, and the Pivot. The three use different fittings and are not interchangeable, so check which device you own before ordering.

Soak it in isopropyl alcohol until the residue lifts, rinse thoroughly with warm water, and let it dry completely before refitting. Glass tolerates a full soak; the atomizer and base do not.

Swab the inside of the bowl with isopropyl alcohol on a cotton bud and wipe the outside contacts dry. Never soak or rinse an atomizer — the heating element and its electrical contacts are inside the assembly.

It changes how the vapor is cooled and filtered, not how the device heats. A recycler or percolated piece cools more and pulls slightly harder; a simple attachment is airier and easier to clean.

The Proxy separates the heater and battery from the glass, so the same stick works in different attachments. Press to start a heat cycle, wait for the ready signal, load the bowl and draw.

Remove the stick from the glass. Soak the glass in isopropyl alcohol, and clean the bowl on the stick with a swab. The stick itself is never submerged.

No. The Proxy and Peak use different fittings, and glass for one will not seat correctly on the other. The Pivot is a third platform again.

No — these are third-party accessories built to fit Puffco hardware, from makers like Wulf Mods and Ryan Fitt. Puffco's own devices are on the Puffco page.

Rarely in the same colorway. Collaborations and worked glass are produced in small runs; standard clear attachments are ordinary stock and do restock.

Whenever the draw feels restricted or the flavor changes — residue builds in the water path faster than in the bowl. Regular short soaks are easier than recovering a neglected piece.